271000595 Impeller Shaft for Sea-Doo Sportster LT 720 2002

Impeller Shaft for Sea-Doo Sportster LT 720

The impeller shaft for Sea-Doo Sportster LT 720 transfers engine power to the jet pump impeller, cross-referenced to OEM part number 271000595.

Overview

This impeller shaft is a replacement driveline component for the Sea-Doo Sportster LT 720 jet boat, carrying torque from the engine into the pump where the impeller generates thrust. The impeller shaft for Sea-Doo Sportster LT 720 is intended for owners addressing vibration, worn splines, or corrosion in the original shaft. It fits the 2002 Sportster LT 720 application.

Built For Performance

• Cross-referenced to OEM part number 271000595 for fitment confirmation
• Machined to engage the factory impeller and pump bearings
• Made from corrosion-resistant material built for marine environments
• Holds alignment under load to keep vibration low
• Rated for the torque output of the 720 engine in jet drive service

Fits These Machines

• for Sea-Doo Sportster LT 720 (2002)

On-The-Job Use

• Jet pump service and impeller replacement
• Correcting vibration or cavitation caused by a bent shaft
• Scheduled driveline maintenance on jet boats
• Returning lost acceleration and thrust after shaft wear

Specs At A Glance

Good To Know

Q: Will this shaft fit other Sportster variants? A: It is referenced to the 2002 Sportster LT 720, so verify your exact model and year before ordering.

Q: Is it worth replacing seals while the pump is apart? A: Replacing pump seals and inspecting bearings during shaft service helps prevent repeat failures and water intrusion.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.