271000874 Jet Pump Nose Cone for Sea-Doo XP 580 1992

Jet Pump Fitting & Outlet Set for Sea-Doo

This jet pump fitting and outlet set is a replacement cooling and bilge plumbing component that routes water through the jet pump assembly on your personal watercraft.

Overview

This jet pump fitting and outlet set is built to replace worn or damaged fittings on the jet pump assembly of your watercraft. The set handles water routing at the pump, where consistent flow keeps the engine and exhaust systems working as intended. It suits riders performing routine pump maintenance or rebuilding a neglected cooling circuit.

Built For Performance

• Direct replacement for the original fitting and outlet positions on the jet pump
• Corrosion-resistant construction suited to constant water exposure
• Precise thread and hose-end sizing for a leak-free seal
• Withstands pump pressure and continuous vibration
• Sold as a set so both fittings are replaced together

Fits These Machines

• for Sea-Doo Challenger 800 (1996-1997)

On-The-Job Use

• Routine jet pump service and cooling system refresh
• Rebuilding a pump assembly after a seal or fitting failure
• Restoring a stored or project watercraft to running condition

Specs At A Glance

Good To Know

Q: Do I need to replace both fittings at once? A: Replacing the full set is recommended, since fittings that share the same service life often fail around the same time. It also saves reopening the pump later.

Q: Are these original brand parts? A: No, this is an aftermarket replacement set designed to fit the listed machine. Confirm your pump configuration before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.