271001179 Trim VTS Rod for Sea-Doo RXP NA 1503 2007

Trim VTS Rod for Sea-Doo

This trim VTS rod is a replacement component for the variable trim system on personal watercraft, letting the VTS nozzle move through its range so the rider can adjust the jet angle while underway.

Overview

This trim VTS rod is a direct-fit replacement for the variable trim system linkage on select Sea-Doo models. The VTS rod connects the trim actuator to the nozzle assembly so trim angle changes translate into the ride attitude you ask for. It suits riders maintaining an older 1503-powered craft or replacing a bent or worn rod.

Built For Performance

• Manufactured to match the original trim VTS rod dimensions
• Rigid construction resists flex under trim load
• Corrosion-resistant finish suited to marine use
• Mounting points sized for the factory VTS hardware
• Direct replacement for part number 271001179

Fits These Machines

• for Sea-Doo RXP S/C 1503, 2004
• for Sea-Doo RXP NA 1503, 2007

On-The-Job Use

• Restoring trim function on a used 1503-powered RXP
• Replacing a bent rod after impact or rough handling
• Routine VTS linkage service on older PWC

Specs At A Glance

Good To Know

Q: Do I need to remove the reverse gate to install this? A: On most 1503-powered RXP craft the rod can be swapped by working from the pump area, though the reverse bucket often has to be moved aside for clearance.

Q: Should I check the VTS motor at the same time? A: Yes, a jammed or failing VTS motor can bend a new rod, so inspect motor travel before fitting the replacement.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.