271001235 Jet Pump Filter for Sea-Doo Spark NA 900 2014

Jet Pump Filter for Sea-Doo

This jet pump filter for Sea-Doo personal watercraft helps keep debris out of the jet pump assembly, protecting the impeller and wear ring by trapping sand, weeds, and small particles before they reach the pump; it references OEM part number 271001235.

Overview

This jet pump filter for Sea-Doo is a direct-fit replacement designed for the Spark NA 900 platform. It installs in the pump housing to strain out debris that can damage internal components and reduce thrust. A sensible choice for riders performing routine maintenance or replacing a worn filter.

Built For Performance

• Traps sand, weeds, and small debris before they enter the jet pump
• Helps protect the impeller and wear ring from abrasive damage
• Built to the dimensions of OEM part 271001235 for a factory-style fit
• Designed for the Sea-Doo Spark NA 900 jet pump assembly
• Simple drop-in installation during routine pump service

Fits These Machines

• for Sea-Doo Spark NA 900 (2014)

On-The-Job Use

• Routine jet pump maintenance on 2014 Sea-Doo Spark NA 900 models
• Riding in shallow or weedy water where debris intake is common
• Replacing a clogged or damaged factory filter during pump service

Specs At A Glance

Good To Know

Q: Do I need to remove the jet pump to install this filter? A: Access varies by model, but the filter sits in the pump assembly and is typically serviced from the pump housing. Check your service manual for the exact procedure on the Spark NA 900.

Q: How often should this filter be replaced? A: Inspect it at each oil change or after riding in sandy or weedy water. Replace it when clogged, torn, or deformed since a blocked filter can restrict flow and hurt pump performance.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.