271001236 Jet Pump Wear Ring 155.5mm for Sea-Doo GTS DT 1503 2014

Jet Pump Wear Ring for Sea-Doo GTS DT 1503

This jet pump wear ring for Sea-Doo is a 155.5 mm ID replacement part that maintains proper impeller clearance in the pump housing, referencing OEM part number 271001236.

Overview

This jet pump wear ring for Sea-Doo restores the critical gap between the impeller and the pump housing so water flow stays strong under load. It is intended for the GTS DT 1503 platform and for riders or technicians servicing the jet pump. A fresh wear ring for Sea-Doo pumps helps bring back the acceleration and top speed lost to wear.

Built For Performance

• 155.5 mm inside diameter matched to the impeller housing bore
• Precision-formed ring profile that holds a tight running clearance
• Corrosion-resistant construction for repeated water exposure
• Wear-resistant bore surface that stands up to pumped debris
• Service-ready part for the 1503 jet pump assembly

Fits These Machines

• for Sea-Doo GTS DT 1503, 2014

On-The-Job Use

• Jet pump servicing on 1503-equipped watercraft
• Seasonal maintenance to keep impeller clearance in spec
• Recovering performance after cavitation or thrust loss
• Repairs following debris ingestion or impeller damage

Specs At A Glance

Good To Know

Q: What are the signs of a worn jet pump wear ring? A: Cavitation, slower hole shots, and a drop in top speed often point to excess clearance between the ring and impeller. Checking the bore against the 155.5 mm spec shows whether it is time to replace.

Q: Is this a complete jet pump rebuild kit? A: This listing is for the wear ring only, and bearings, seals, and fasteners are ordered separately if the full pump is being rebuilt. Many jobs reuse original hardware when it remains serviceable.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.