271001534 Drive Shaft for Sea-Doo GTI STD DT 1503 2007 23-1/4

Drive Shaft for Sea-Doo

This 23-1/4 inch drive shaft for Sea-Doo links the engine to the jet pump so torque reaches the impeller, and it cross-references OEM part number 271001534.

Overview

This drive shaft for Sea-Doo is a replacement propulsion component measuring 23-1/4 inches for the 1503 engine platform. It delivers engine torque to the jet pump, allowing the impeller to spin and push the watercraft. It fits riders and techs servicing a GTI STD or DT that needs a fresh drive shaft for Sea-Doo.

Built For Performance

• 23-1/4 inch length for correct fitment and spline engagement
• Cross-references OEM part number 271001534
• Precision splines at both ends for reliable torque transfer
• Corrosion-resistant steel suited to marine conditions
• Balanced geometry to reduce vibration under load

Fits These Machines

• for Sea-Doo GTI STD with 1503 engine, 2007
• for Sea-Doo GTI DT with 1503 engine, 2007

On-The-Job Use

• Replacing a worn or damaged shaft on a 2007 GTI STD or DT
• Jet pump service and driveline inspection
• Rebuilding after engine or pump removal

Specs At A Glance

Good To Know

Q: How can I confirm this shaft fits my craft? A: Match OEM number 271001534 and the 23-1/4 inch length to your current shaft, and verify the model and year listed for this Sea-Doo.

Q: Should I replace seals or bearings too? A: Inspect and replace drive shaft seals and bearings while the shaft is out so the new part runs on clean wear surfaces.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.