271001681 Carbon Ring for Sea-Doo Wake 155 1503 2009-2010

Carbon Ring for Sea-Doo

The carbon ring for Sea-Doo personal watercraft, OEM cross-reference 271001681, seals the driveshaft to the impeller housing to keep water out of the hull.

Overview

This carbon ring for Sea-Doo is a driveshaft seal component that keeps water from entering the hull where the shaft passes through the impeller housing. It fits 1503-powered models and supports the seal face against the stainless ring during operation. The carbon ring for Sea-Doo is a direct cross-reference to 271001681.

Built For Performance

• Cross-references OEM part number 271001681
• Carbon sealing face runs against the stainless ring for a tight seal
• Rated for the 1503 engine platform
• Withstands constant water contact and driveshaft rotation
• Direct replacement for worn or cracked seal rings

Fits These Machines

• for Sea-Doo Wake 155 with 1503 engine, 2009-2010

On-The-Job Use

• Rebuilding the driveshaft seal assembly on 1503-powered Sea-Doo craft
• Replacing a leaking or worn carbon ring during routine driveline service
• Restoring the seal face after impeller or wear ring replacement
• Post-season maintenance on Sea-Doo Wake 155 models

Specs At A Glance

Good To Know

Q: Does this carbon ring fit any 1503 engine? A: It is listed for the Sea-Doo Wake 155 with the 1503 engine from 2009 to 2010, so verify your model and year before ordering. Q: Can I install this without removing the driveshaft? A: Carbon ring replacement typically requires separating the driveshaft from the impeller housing, so plan for driveline disassembly.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.