271001892 Support Ring for Sea-Doo RXP 155 S/C 1503 2008

Support Ring for Sea-Doo RXP 155 S/C 1503

The Support Ring, part number 271001892, is a driveline component that secures and stabilizes the jet pump assembly on 2008 Sea-Doo RXP 155 S/C 1503 watercraft.

Overview

This support ring for Sea-Doo fits at the pump mounting point to keep the impeller and driveshaft aligned under load. It is a direct replacement for the original 271001892 support ring, helping riders restore proper pump seating. Built for owners servicing a 2008 RXP 155 S/C 1503, this ring keeps the jet pump assembly firmly in place.

Built For Performance

• Direct replacement for part number 271001892
• Keeps jet pump housing aligned with the driveshaft
• Rigid construction resists flex under thrust load
• Mounts with factory hardware points for a drop-in fit
• Helps reduce vibration and pump shake during hard acceleration

Fits These Machines

• for Sea-Doo RXP 155 S/C 1503, 2008

On-The-Job Use

• Jet pump reassembly after impeller or wear ring service
• Routine driveline inspection and parts replacement
• Restoring correct pump alignment on a 2008 RXP 155 S/C 1503

Specs At A Glance

Good To Know

Q: Does this ring replace the factory part directly? A: Yes, it matches part number 271001892 and installs at the same pump mounting location as the original. Confirm your hull serial number before ordering.

Q: Can I reuse the old mounting hardware? A: Factory bolts often work again if they are clean and undamaged, though new hardware is a safer choice on a jet pump assembly. Inspect threads before refitting.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.