271002109 Carbon Ring for Sea-Doo Explorer Pro 230 1630 2024-2026

Carbon Ring for Sea-Doo

This carbon ring, part number 271002109, is a replacement sealing component that fits between the driveshaft and the hull seal to keep water out of the engine compartment on select Sea-Doo watercraft.

Overview

The carbon ring for Sea-Doo is a wear item that seals the driveshaft passage on personal watercraft. This carbon ring, part number 271002109, helps prevent water intrusion while allowing the driveshaft to spin freely. It is intended for riders performing routine driveline maintenance on their Sea-Doo.

Built For Performance

• Carbon sealing face designed to run against the floating ring for a low-friction seal
• Replaces worn or scored rings that allow water past the driveshaft seal
• Direct fit for the listed part number 271002109 application
• Constructed for continuous contact with the driveshaft during operation
• Simple component to service during driveline inspection

Fits These Machines

• for Sea-Doo Explorer Pro 230 1630, 2024-2026

On-The-Job Use

• Routine driveshaft seal maintenance on personal watercraft
• Replacing a worn carbon ring after water intrusion is found
• Driveline service during impeller or wear ring replacement
• Seasonal prep for riders storing or recommissioning their craft

Specs At A Glance

Good To Know

Q: How do I know if my carbon ring needs replacing? A: Common signs include water in the hull, a scored or worn sealing face, or visible damage found during driveline inspection.

Q: Does this come as a complete seal assembly? A: This listing covers the carbon ring component identified by part number 271002109, so check your parts diagram for any related seals or retainers you may also need.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.