271002109 Carbon Ring for Sea-Doo GTR 230 1630 2023-2026

Carbon Ring for Sea-Doo GTR 230 1630

This carbon ring (OEM cross-reference 271002109) is a driveshaft seal component that keeps water out of the hull where the shaft passes through, and it is built for the Sea-Doo GTR 230 1630 from 2023 through 2026.

Overview

This carbon ring serves as the sealing element in the driveshaft tunnel of the Sea-Doo GTR 230 1630, helping keep water where it belongs while the shaft spins. It is a direct-fit replacement for OEM 271002109, so riders can restore a proper seal without hunting down obsolete parts. This carbon ring suits PWC owners and mechanics handling routine driveline maintenance on the GTR 230 1630.

Built For Performance

• Constructed from carbon-based sealing material for smooth contact against the rotating driveshaft
• Designed to match OEM 271002109 dimensions for direct replacement
• Helps maintain a watertight seal at the hull pass-through point
• Withstands continuous contact with a spinning shaft under load
• Fits the 1630 engine platform used in the GTR 230

Fits These Machines

• for Sea-Doo GTR 230 1630 (2023-2026)

On-The-Job Use

• Routine driveshaft seal replacement during driveline service
• Hull pass-through maintenance after seasonal use
• Repair work when water intrusion is traced to the shaft seal area
• Preventive maintenance on the GTR 230 1630 platform

Specs At A Glance

Good To Know

Q: Is this an original Sea-Doo part? A: This is an aftermarket carbon ring that cross-references OEM 271002109, and it is not manufactured by Sea-Doo.

Q: Do I need to replace anything else at the same time? A: Carbon rings are commonly serviced alongside the mating seal surfaces and related driveshaft hardware, so inspect those parts while the driveline is apart.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.