271002109 Carbon Ring for Sea-Doo GTX 155 1503 2010-2013 2015-2016

Carbon Ring for Sea-Doo GTX 155 1503

This carbon ring seals the driveshaft to the impeller on the Sea-Doo GTX GTX 155 1503, replacing OEM 271002109 and keeping water out of the hull.

Overview

The carbon ring for Sea-Doo GTX 155 1503 is a wear component that rides against the floating ring inside the jet pump assembly, holding the driveshaft seal tight while the engine is running. It suits riders maintaining a GTX 155 from model years 2010 through 2016 who need a fresh seal ring without replacing the entire seal carrier. This carbon ring for Sea-Doo GTX 155 is a direct-fit service part cross-referenced to 271002109.

Built For Performance

• Carbon face material designed to run against the stainless floating ring
• Direct replacement for OEM part number 271002109
• Fits the 1503 engine seal carrier used across GTX 155 model years
• Pre-formed to the seat diameter so it presses in without machining
• Resists heat generated by constant shaft rotation in the pump tunnel

Fits These Machines

• for Sea-Doo GTX 155 1503 (2010-2013)
• for Sea-Doo GTX 155 1503 (2015-2016)

On-The-Job Use

• Routine jet pump seal service
• Driveshaft reseal after pump removal
• Repairing water intrusion around the shaft tunnel
• Maintenance before a riding season

Specs At A Glance

Good To Know

Q: Do I need to replace the floating ring too? A: It is good practice to inspect the floating ring and replace it if the face is scored or worn, since a new carbon ring against a rough ring will not seal properly.

Q: Will this ring fit my model year exactly? A: It is listed for GTX 155 models from 2010-2013 and 2015-2016 with the 1503 engine, and compatibility can depend on serial number, so confirm your machine's fitment before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.