271002109 Carbon Ring for Sea-Doo GTX LTD 230 1503 2017

Carbon Ring for Sea-Doo

This carbon ring, part number 271002109, seals the driveshaft interface on select Sea-Doo personal watercraft to keep water out of the hull.

Overview

This carbon ring is a direct-fit sealing component for the driveshaft on select Sea-Doo models. It works with the floating seal assembly to prevent water intrusion where the shaft passes through the hull. This carbon ring suits riders performing routine driveline maintenance on their Sea-Doo watercraft.

Built For Performance

• Carbon sealing surface designed for low-friction contact against the driveshaft
• Direct replacement for part number 271002109
• Withstands continuous immersion in marine conditions
• Precision-fit dimensions for the seal carrier assembly
• Helps maintain a watertight seal at the hull pass-through

Fits These Machines

• for Sea-Doo GTX LTD 230 1503, 2017

On-The-Job Use

• Routine driveshaft seal replacement
• Driveline service after pulling the engine or pump
• Seasonal maintenance on personal watercraft
• Repair of water intrusion at the shaft seal

Specs At A Glance

Good To Know

Q: How often should a carbon ring be replaced? A: Inspect it whenever the pump or engine is removed and replace it if the sealing surface shows wear, cracks, or grooving. Many riders replace it as part of scheduled driveline service.

Q: Does this ring come with the carrier or boot? A: This listing covers the carbon ring itself as indicated by part number 271002109. Check your parts diagram to confirm whether additional seal components are needed for your assembly.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.