271002109 Carbon Ring for Sea-Doo GTX LTD IS 260 1503 2010-2016

Carbon Ring for Sea-Doo

This carbon ring, OEM cross-reference 271002109, seals the driveshaft interface on Sea-Doo personal watercraft to keep water out of the hull.

Overview

This carbon ring is a driveshaft seal component made for Sea-Doo personal watercraft, referencing OEM part number 271002109. The carbon ring seals the gap between the driveshaft and the hull tunnel, keeping water from entering the engine compartment while the craft is in use. It is a maintenance item suited to riders performing routine driveline service on their Sea-Doo.

Built For Performance

• Carbon sealing face designed to run against the driveshaft support ring
• Direct reference to OEM part number 271002109 for confident matching
• Seals the hull tunnel pass-through against water intrusion
• Wear item intended for replacement during driveline service
• Fits 1503 engine applications listed for this part number

Fits These Machines

• for Sea-Doo GTX LTD IS 260 1503, 2010-2016

On-The-Job Use

• Routine driveshaft seal replacement on 1503-powered Sea-Doo craft
• Driveline service when the hull tunnel shows water seepage
• Seasonal maintenance before launching the craft

Specs At A Glance

Good To Know

Q: How do I know this carbon ring fits my craft? A: Confirm your model and serial number against the OEM part number 271002109 listing before ordering. Fit can vary by model year and driveline configuration.

Q: Does the carbon ring need to be replaced on a schedule? A: It is a wear item, so inspect it during driveline service and replace it when the sealing face shows scoring, cracking, or excess wear. Replacing it helps prevent water intrusion at the hull tunnel.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.