271002109 Carbon Ring for Sea-Doo GTX STD 170 1630 2023-2026

Carbon Ring for Sea-Doo

The carbon ring, part number 271002109, is a driveshaft seal component that helps keep water out of the hull on for Sea-Doo personal watercraft.

Overview

This carbon ring for Sea-Doo is a replacement sealing component for the driveshaft through-hull area, helping prevent water intrusion while the craft is underway. The carbon ring for Sea-Doo works with the floating seal assembly to maintain a tight barrier between the engine compartment and the jet pump tunnel. It is intended for riders performing routine driveline maintenance on their for Sea-Doo watercraft.

Built For Performance

• Carbon sealing face designed to run against the stainless steel driveshaft ring
• Helps block water from entering the hull through the driveshaft passage
• Direct replacement for part number 271002109
• Suited to the 1630 engine platform used in the GTX STD 170
• Contact surface engineered to wear evenly under continuous rotation

Fits These Machines

• for Sea-Doo GTX STD 170 1630, 2023-2026

On-The-Job Use

• Seasonal driveline inspection and seal replacement
• Servicing after pulling the jet pump for maintenance
• Addressing water seepage around the driveshaft tunnel
• Routine hull and driveline rebuilds

Specs At A Glance

Good To Know

Q: Does this carbon ring fit both the 230 and 170 GTX STD models? A: This listing is for the for Sea-Doo GTX STD 170 1630, and fitment should be confirmed against your model and serial number before ordering.

Q: Can the carbon ring be reused once removed? A: Carbon seal rings are typically replaced rather than reused, since the sealing face wears to match its mating surface and may not seal correctly if reinstalled.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.