271002109 Carbon Ring for Sea-Doo RXT X 260 1503 2010-2015

Carbon Ring for Sea-Doo RXT X 260 1503

This carbon ring (OEM 271002109) seals the driveshaft to the hull on 1503cc Sea-Doo RXT X 260 models, preventing water from entering the engine bay through the driveshaft tunnel.

Overview

This carbon ring is a direct-fit replacement seal for the driveshaft tunnel on 2010-2015 Sea-Doo RXT X 260 1503 models. It carries the same OEM 271002109 cross-reference as the factory piece, so it installs onto the stock driveshaft bearing carrier without modification. Owners of a Sea-Doo RXT X 260 replacing a worn or leaking carbon ring will find this part restores the watertight seal between the hull and jet pump tunnel.

Built For Performance

• Direct cross-reference to OEM part number 271002109
• Carbon sealing face designed to ride against the driveshaft sleeve
• Holds up to continuous water exposure inside the hull tunnel
• Blocks engine bay water intrusion from the pump side
• Keeps driveshaft alignment correct at the bearing carrier

Fits These Machines

• for Sea-Doo RXT X 260 1503 (2010-2015)

On-The-Job Use

• Driveshaft tunnel sealing on 1503cc RXT X 260 models
• Replacement during carbon ring wear or driveshaft service
• Repair after water intrusion is found in the engine bay
• Routine driveline upkeep on 2010-2015 RXT X 260 skis

Specs At A Glance

Good To Know

Q: Does this fit my 2013 RXT X 260? A: This part is listed for the 2010-2015 RXT X 260 1503, so verify your model year and serial number before ordering.

Q: Should I replace the carbon ring every time the driveshaft is removed? A: A worn carbon ring will not seal correctly, so replacement during driveshaft service is the safe approach.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.