271002109 Carbon Ring for Sea-Doo RXT X 300 1630 2016-2017 2023

Carbon Ring for Sea-Doo RXT X 300 1630

This carbon ring (OEM 271002109) seals the driveshaft to the hull on 1630cc Sea-Doo RXT X 300 models, keeping water out of the engine bay and holding proper driveline alignment.

Overview

This carbon ring is a direct-fit replacement seal for the driveshaft tunnel on 2016-2017 and 2023 Sea-Doo RXT X 300 1630 models. It uses the same OEM 271002109 cross-reference as the factory part, so it seats and seals properly on the stock driveshaft bearing carrier. Riders replacing a worn or leaking carbon ring on a Sea-Doo RXT X 300 will find this part restores the watertight seal between the engine bay and the jet pump tunnel.

Built For Performance

• Direct cross-reference to OEM part number 271002109
• Carbon sealing face designed to grip the driveshaft sleeve
• Withstands constant water exposure in the hull tunnel
• Seals the engine bay from pump-side water intrusion
• Maintains proper driveshaft alignment at the bearing carrier

Fits These Machines

• for Sea-Doo RXT X 300 1630 (2016-2017)
• for Sea-Doo RXT X 300 1630 (2023)

On-The-Job Use

• Driveshaft tunnel sealing on 1630cc RXT X 300 models
• Routine replacement during carbon ring wear or driveshaft service
• Repair after water intrusion is found in the engine bay
• Driveline maintenance on 2016-2017 and 2023 RXT X 300 skis

Specs At A Glance

Good To Know

Q: Does this fit my 2018 RXT X 300? A: This part is listed for the 2016-2017 and 2023 RXT X 300 1630, so confirm your model year before ordering.

Q: Can I reuse the old carbon ring during driveshaft service? A: A worn or cracked carbon ring will not seal properly, so replace it whenever the driveshaft is serviced or water intrusion is present.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.