271002109 Carbon Ring for Sea-Doo RXT XRS 300 1630 2017

Carbon Ring for Sea-Doo

The carbon ring for Sea-Doo personal watercraft, part number 271002109, seals the driveshaft to the impeller housing to keep water out and thrust steady.

Overview

This carbon ring for Sea-Doo is the sealing component that fits between the driveshaft and the impeller housing on RXT XRS 300 1630 models. It keeps lake water from entering the hull through the shaft tunnel while holding a stable seal under load. Riders replacing a worn or cracked ring will find this a direct-fit option for routine driveline service.

Built For Performance

• Direct cross-reference to OEM part number 271002109
• Carbon sealing face designed for continuous shaft rotation
• Resists wear from grit and debris pulled through the tunnel
• Maintains seal pressure under high-rpm operation
• Simple replacement during driveshaft or impeller service

Fits These Machines

• for Sea-Doo RXT XRS 300 1630, 2017

On-The-Job Use

• Routine driveshaft seal replacement
• Impeller housing rebuilds
• Post-season maintenance checks
• Repairing water intrusion at the shaft tunnel

Specs At A Glance

Good To Know

Q: How often should the carbon ring be replaced? A: Many riders replace it during driveshaft or impeller service, or whenever the seal face shows cracking, scoring, or heavy wear. Q: Can a worn carbon ring cause water in the hull? A: Yes, a worn or damaged ring is a common source of water leaking into the hull at the shaft tunnel, so replacing it early helps avoid that issue.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.