271002109 Carbon Ring for Sea-Doo Spark TRIXX 1Up 900 2024-2026

Carbon Ring for Sea-Doo

The carbon ring for Sea-Doo is a driveshaft seal component that helps block water at the hull pass-through, and it cross-references OEM 271002109.

Overview

This carbon ring for Sea-Doo is a replacement seal for the driveshaft opening on Spark TRIXX 1Up 900 models. It helps keep water out of the engine bay where the shaft exits the hull, supporting a dry, smooth-running driveline. It is aimed at owners handling their own watercraft service or swapping out a worn carbon ring for Sea-Doo as part of driveline upkeep.

Built For Performance

• Carbon sealing face that rides against the driveshaft seal surface
• Cross-references OEM part number 271002109
• Helps limit water intrusion at the hull pass-through
• Built for the 900 ACE engine platform used in Spark TRIXX models
• Ring format that mounts on the driveshaft in the stock location

Fits These Machines

• for Sea-Doo Spark TRIXX 1Up 900, 2024
• for Sea-Doo Spark TRIXX 1Up 900, 2025
• for Sea-Doo Spark TRIXX 1Up 900, 2026

On-The-Job Use

• Driveshaft and seal service on personal watercraft
• Replacing a worn or leaking carbon ring at the hull opening
• Pump and driveline maintenance on Spark TRIXX models
• Seasonal checks of the shaft seal area before riding

Specs At A Glance

Good To Know

Q: When should a carbon ring be replaced? A: It is commonly replaced during driveshaft or pump service, or once water intrusion or visible wear appears at the hull opening. A quick seasonal check helps spot wear early.

Q: Is this the only seal needed for the driveshaft? A: This listing covers the carbon ring referenced as 271002109. Inspect the surrounding seal and boot for wear and replace those separately if needed.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.