271002109 Carbon Ring for Sea-Doo Sport 21-300 1630 2026

Carbon Ring for Sea-Doo Sport 21-300 1630

This carbon ring, part number 271002109, is a replacement driveshaft seal component that helps keep water out of the hull on Sea-Doo Sport 21-300 1630 watercraft from 2026.

Overview

The carbon ring for Sea-Doo provides a wear surface and seal where the driveshaft passes through the hull, helping limit water intrusion while the craft is in operation. This carbon ring 271002109 is intended for riders and DIY mechanics performing driveline maintenance on their Sea-Doo Sport 21-300 1630. As a service part, it supports routine upkeep of the seal interface so the craft stays ready for the water.

Built For Performance

• Carbon sealing face designed to ride against the driveshaft seal for consistent contact
• Direct replacement for part number 271002109
• Suited to the 1630 engine platform used in the Sport 21-300
• Helps reduce water entry at the driveshaft pass-through
• Simple component for routine driveline service and inspection

Fits These Machines

• for Sea-Doo Sport 21-300 1630 (2026)

On-The-Job Use

• Routine driveshaft seal maintenance on Sea-Doo personal watercraft
• Replacing a worn or scored carbon ring during driveline service
• Seasonal inspection of the seal interface before launching
• Workshop repair for water intrusion at the driveshaft pass-through

Specs At A Glance

Good To Know

Q: Is this an original Sea-Doo part? A: This is a replacement carbon ring for Sea-Doo applications and is referenced by part number 271002109. Confirm your model and part number before ordering.

Q: Should the carbon ring be replaced on its own? A: It is typically serviced as part of the driveshaft seal assembly, so inspect related seal components at the same time. Follow your service manual for the correct procedure.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.