271002228 Impeller Boot for Sea-Doo GTI 130 Rental 1630 2020

Impeller Boot for Sea-Doo

This impeller boot for Sea-Doo is a replacement driveline seal designed to protect the impeller shaft connection on 1630-based watercraft, referencing OEM part number 271002228.

Overview

This impeller boot for Sea-Doo serves as a protective rubber seal at the impeller shaft, helping keep water and debris away from the driveline connection. It is built for riders and rental fleets running 1630-engine models such as the GTI 130. The impeller boot for Sea-Doo is a straightforward replacement part for routine driveline maintenance.

Built For Performance

• Direct-fit replacement referencing OEM part 271002228
• Flexible rubber construction absorbs driveline movement
• Helps seal the impeller shaft area from water intrusion
• Withstands repeated immersion and high-RPM operation
• Simple installation during pump or shaft service

Fits These Machines

• for Sea-Doo GTI 130 Rental 1630 (2020)

On-The-Job Use

• Routine impeller shaft service
• Jet pump removal and reassembly
• Rental fleet driveline maintenance
• Seasonal watercraft refresh

Specs At A Glance

Good To Know

Q: Does this come with mounting hardware? A: This listing covers the impeller boot itself; reuse or source any retainers as needed for your pump assembly.

Q: How often should an impeller boot be replaced? A: Inspect it whenever the jet pump is serviced and replace it if you find cracking, hardening, or tears.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.