271002228 Impeller Boot for Sea-Doo GTI STD Rental 1503 2019

Impeller Boot for Sea-Doo

This impeller boot is a direct replacement seal for the jet pump drive on personal watercraft, cross-referencing OEM part 271002228, and it keeps water and debris out of the impeller shaft assembly.

Overview

This impeller boot for Sea-Doo is a rubber sealing component that fits over the impeller shaft at the jet pump, protecting bearings and seals from water intrusion. Replacing a worn or cracked impeller boot helps maintain proper driveline lubrication on your watercraft. Designed for riders performing routine jet pump maintenance, this impeller boot matches OEM 271002228 for a dependable fit.

Built For Performance

• Cross-references OEM part 271002228 for easy verification
• Flexible rubber construction resists cracking from constant water exposure
• Seals the impeller shaft against water and debris intrusion
• Helps protect pump bearings and driveline components
• Direct-fit replacement for routine jet pump service

Fits These Machines

• for Sea-Doo GTI STD Rental 1503, 2019

On-The-Job Use

• Routine jet pump seal replacement
• Driveline maintenance on personal watercraft
• Restoring watertight protection at the impeller shaft

Specs At A Glance

Good To Know

Q: How do I know when the impeller boot needs replacing? A: Cracks, hardening, or water in the pump area usually indicate wear, so inspect the boot during jet pump service. Q: Does this boot require any special tools to install? A: Installation follows standard jet pump disassembly procedures, and the boot seats over the impeller shaft like the original.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.