271002228 Impeller Boot for Sea-Doo GTR P STD 230 1503 2018

Impeller Boot for Sea-Doo

This impeller boot is a replacement wear component for the jet pump of personal watercraft, sealing the drive shaft and protecting the pump internals from water intrusion, and it is identified by OEM cross-reference 271002228.

Overview

This impeller boot is a direct-fit replacement wear part for the jet pump assembly on select personal watercraft. The impeller boot seals around the drive shaft to keep water out and lubricant in, helping the pump run smoothly. It is a smart choice for riders handling routine pump maintenance or a rebuild.

Built For Performance

• Seals the drive shaft area against water intrusion
• Helps retain lubrication within the pump assembly
• Reinforced rubber construction suited to constant water exposure
• Direct fit replacement identified by OEM cross-reference 271002228
• Straightforward installation during pump or shaft service

Fits These Machines

• for Sea-Doo GTR P STD 230 1503, 2018

On-The-Job Use

• Routine jet pump maintenance and rebuilds
• Replacing a cracked or worn shaft seal boot
• Seasonal servicing of personal watercraft
• Repair work after water intrusion is found in the pump

Specs At A Glance

Good To Know

Q: How often should the impeller boot be replaced? A: Many riders replace it during any pump rebuild or whenever the shaft is removed, since wear and cracking develop over time. Inspecting it each season is a practical habit.

Q: Is this an original manufacturer part? A: This is an aftermarket replacement part identified by OEM cross-reference 271002228. It is not an original brand product.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.