271002228 Impeller Boot for Sea-Doo GTX P LTD 230 1503 2018

Impeller Boot for Sea-Doo

This impeller boot is a direct-fit replacement for the OEM part referenced as 271002228, sealing the jet pump drive shaft area on your personal watercraft.

Overview

This impeller boot for Sea-Doo is the protective seal that sits at the jet pump, keeping water where it belongs and shielding the impeller shaft interface from debris. It restores the sealing layer on your PWC jet pump, so the impeller boot for Sea-Doo does the same job as the factory part. It is made for riders replacing a worn, cracked, or missing boot on their 2018 GTX P LTD 230 1503.

Built For Performance

• Direct cross-reference for OEM part number 271002228
• Seals the jet pump impeller shaft area against water intrusion
• Rubber construction flexes with normal driveline movement
• Shields the shaft interface from sand and debris
• Fits the 1503 engine platform jet pump setup

Fits These Machines

• for Sea-Doo GTX P LTD 230 1503 (2018)

On-The-Job Use

• Replacing a cracked or hardened original boot during pump service
• Routine jet pump teardown and inspection
• Restoring sealing after impeller or wear ring work
• Preventive maintenance on high-hour 1503-powered craft

Specs At A Glance

Good To Know

Q: Does this replace the original part on my PWC? A: It cross-references OEM 271002228, so it installs in the same location on the jet pump for the listed model. Confirm your machine's part number before ordering.

Q: When should the impeller boot be replaced? A: Replace it any time the pump is apart or when you notice cracking, hardening, or missing rubber. A failed boot lets water and debris reach the shaft area.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.