271002228 Impeller Boot for Sea-Doo RXT P XRS 300 1630 2018

Impeller Boot for Sea-Doo

This impeller boot for Sea-Doo RXT P XRS 300 1630 watercraft (OEM cross-reference 271002228) seals the impeller shaft area to keep water out of the jet pump assembly.

Overview

This impeller boot for Sea-Doo is a direct-fit replacement sealing component for the jet propulsion system. The impeller boot for Sea-Doo helps protect critical pump internals from water intrusion and debris during operation. It is intended for riders performing routine maintenance or pump rebuilds on the RXT P XRS 300 1630.

Built For Performance

• OEM cross-reference 271002228 for accurate fitment
• Flexible rubber construction for a snug seal
• Resists water, salt, and fuel exposure
• Designed for jet pump shaft sealing applications
• Direct replacement for worn or cracked boots

Fits These Machines

• for Sea-Doo RXT P XRS 300 1630

On-The-Job Use

• Jet pump rebuilds and impeller service
• Routine driveline maintenance on personal watercraft
• Replacing cracked or dried-out boots

Specs At A Glance

Good To Know

Q: How do I know if my impeller boot needs replacing? A: Inspect for cracks, stiffness, or water intrusion around the pump housing during routine service. A worn boot should be replaced before it lets debris reach the shaft seal.

Q: Does this boot require special tools to install? A: Basic hand tools and a service manual for your model are typically sufficient. Confirm the pump assembly is properly seated after installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.