271002228 Impeller Boot for Sea-Doo SP 1x260 1503 2012

Impeller Boot for Sea-Doo SP

The impeller boot is a replacement sealing component that fits between the driveshaft and impeller housing, helping keep water out of the jet pump assembly on 2012 Sea-Doo SP models equipped with the 1503 engine, and carries OEM cross-reference 271002228.

Overview

This impeller boot serves as a protective seal for the jet pump driveshaft area on the Sea-Doo SP with the 1503 engine. It helps guard against water intrusion and keeps the impeller and wear ring interface running as intended. A direct-fit replacement for riders performing routine pump maintenance or addressing a worn seal, this impeller boot for Sea-Doo keeps the jet propulsion system sealed where it counts.

Built For Performance

• Direct replacement for OEM part number 271002228
• Constructed from durable rubber to resist water and wear
• Seals the impeller housing area against water intrusion
• Pre-formed to match the factory mounting surface
• Designed specifically for the 1503 engine jet pump assembly

Fits These Machines

• for Sea-Doo SP with 1503 engine (2012)

On-The-Job Use

• Jet pump rebuilds and driveshaft seal replacement
• Routine maintenance on 1503-equipped personal watercraft
• Correcting water intrusion in the pump housing area
• Restoring the seal after impeller or wear ring service

Specs At A Glance

Good To Know

Q: Does this boot come with the OEM part number printed or labeled? A: It is cross-referenced to 271002228, so verify your machine's part number before ordering.

Q: Can I install this impeller boot myself? A: Installation typically requires removing the jet pump assembly, so basic mechanical experience and the correct tools are recommended.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.