271002228 Impeller Boot for Sea-Doo SP 2x260 1503 2012

Impeller Boot for Sea-Doo

The impeller boot for Sea-Doo SP 2 x 260 1503 is a replacement driveline seal that fits over the impeller shaft to keep water out of the jet pump assembly, and it cross-references OEM part number 271002228.

Overview

This impeller boot for Sea-Doo is a direct-fit replacement seal for the jet pump driveline on the SP 2 x 260 1503 platform. It shields the impeller shaft connection from water intrusion and keeps the pump running clean, making it a practical part for riders doing their own pump maintenance. The impeller boot for Sea-Doo installs in place of the original part using the same mounting points.

Built For Performance

• OEM cross-reference 271002228 for straightforward part matching
• Flexible rubber construction that seals around the impeller shaft
• Resists water intrusion into the jet pump driveline
• Built to handle the vibration and load of a 260 hp 1503 engine
• Direct replacement fit for the SP 2 x 260 jet pump assembly

Fits These Machines

• for Sea-Doo SP 2 x 260 1503

On-The-Job Use

• Routine jet pump and driveline maintenance
• Replacing a cracked or worn impeller boot after inspection
• Rebuilding the pump after pulling the impeller shaft
• Seasonal service on personal watercraft

Specs At A Glance

Good To Know

Q: Is this an original Sea-Doo part? A: This is a replacement impeller boot that cross-references OEM part number 271002228, and it is not an original brand product.

Q: Do I need to remove the pump to install it? A: The impeller boot sits on the driveline at the pump, so confirming the shaft and housing condition before ordering is recommended.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.