271002228 Impeller Boot for Sea-Doo Speedster Wake 430 1503 2008

Impeller Boot for Sea-Doo

This impeller boot is a replacement driveshaft seal component that protects the jet pump impeller shaft area from water intrusion on personal watercraft.

Overview

This impeller boot serves as a protective seal at the impeller shaft on jet propulsion systems, helping keep water and debris away from critical driveline components. Built as a direct replacement for OEM part 271002228, this impeller boot is suited to riders performing routine pump maintenance or replacing a worn, cracked seal. Installation follows standard jet pump service procedures for the Sea-Doo platform.

Built For Performance

• Direct replacement for OEM part number 271002228
• Flexible rubber construction resists cracking and fatigue
• Seals the impeller shaft area against water intrusion
• Compatible with the 1503 engine platform
• Simple install during routine jet pump service

Fits These Machines

• for Sea-Doo Speedster Wake 430 (2008)

On-The-Job Use

• Jet pump impeller shaft sealing on personal watercraft
• Routine pump inspection and rebuild service
• Replacing a worn or cracked factory boot
• Seasonal maintenance before launching

Specs At A Glance

Good To Know

Q: What does an impeller boot do? A: It seals the impeller shaft area on the jet pump to keep water and debris out of the driveline. A torn boot should be replaced before it causes further wear.

Q: Does this fit my exact model year? A: This boot is listed for the 2008 Sea-Doo Speedster Wake 430 with the 1503 engine. Confirm your model and serial number before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.