271002228 Impeller Boot for Sea-Doo Wake Pro 230 1630 2020-2026

Impeller Boot for Sea-Doo

This impeller boot is a replacement sealing component for the jet pump of select Sea-Doo personal watercraft, designed to protect the impeller shaft area from water intrusion and debris.

Overview

The impeller boot is a critical wear item in the jet pump assembly of a personal watercraft, sealing the impeller shaft against water and grit. This replacement impeller boot is built to fit Sea-Doo models and helps keep the pump running smoothly. It is intended for riders performing routine maintenance or replacing a worn or cracked boot.

Built For Performance

• Direct replacement for OEM part number 271002228
• Constructed from durable rubber for long service life
• Seals the impeller shaft against water intrusion
• Helps protect pump bearings from debris and moisture
• Flexible design allows easy installation on the shaft

Fits These Machines

• for Sea-Doo Wake Pro 230 1630 (2020-2026)

On-The-Job Use

• Routine jet pump maintenance and rebuilds
• Replacing a cracked or worn impeller boot
• Seasonal service on personal watercraft
• Keeping debris and water out of the pump assembly

Specs At A Glance

Good To Know

Q: How often should I replace the impeller boot? A: Inspect it during every jet pump service and replace it if you find cracks, hardening, or gaps around the shaft.

Q: Does this fit my 1630 engine model? A: It is listed for the Sea-Doo Wake Pro 230 1630 from 2020 to 2026, but always confirm your serial number and pump configuration before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.