272000001 PTO Side Rubber Boot for Sea-Doo GT 580 1990-1991

PTO Side Rubber Boot for Sea-Doo

This PTO side rubber boot (OEM cross-reference 272000001) seals the drive shaft passage on the engine case to keep water and debris out of the PTO area.

Overview

This PTO side rubber boot is a direct-fit seal for the power take-off side of the engine on personal watercraft. The boot keeps water, grit, and spray away from the PTO coupler and shaft bore so the driveline stays protected during regular riding. It is built for riders maintaining or restoring a Sea-Doo GT 580 between 1990 and 1991.

Built For Performance

• OEM cross-reference 272000001 for accurate fitment
• Flexible rubber construction absorbs vibration and misalignment
• Seals the PTO shaft opening against water intrusion
• Resists fuel, oil, and UV exposure common in marine use
• Simple press-on installation with basic hand tools

Fits These Machines

• for Sea-Doo GT 580 1990
• for Sea-Doo GT 580 1991

On-The-Job Use

• Routine replacement of a cracked or hardened factory boot
• Driveline service on the PTO side of the engine
• Restoration of a vintage Sea-Doo GT 580
• Pre-season inspection before launching

Specs At A Glance

Good To Know

Q: How do I know if my PTO boot needs replacing? A: Cracks, stiffness, or a loose fit around the shaft are signs the rubber has aged past its service life. Replacing it early prevents water from reaching the PTO coupler.

Q: Does this boot come with mounting hardware? A: This listing covers the rubber boot only, and factory clamps or retaining rings are normally reused. Inspect existing hardware and replace it if corroded before reinstalling.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.