272000012400 Seal Carrier Assembly for Sea-Doo 3D DI 951 2006-2007

Seal Carrier Assembly for Sea-Doo

This seal carrier assembly is a replacement driveline component that supports and seals the driveshaft where it exits the hull on 951 DI powered watercraft, and it is referenced by OEM number 272000012400.

Overview

This seal carrier assembly is the housing and sealing unit that keeps water out while the driveshaft spins on Sea-Doo 3D DI 951 machines. As a direct cross-reference to 272000012400, this seal carrier assembly helps restore a proper seal at the hull pass-through. It is intended for riders performing routine driveline maintenance on their 2006 to 2007 3D DI.

Built For Performance

• Cross-references OEM part number 272000012400 for straightforward replacement
• Houses the driveshaft seal at the hull pass-through point
• Helps prevent water intrusion into the engine compartment
• Designed for 951 DI driveline configurations
• Supports stable driveshaft alignment during operation

Fits These Machines

• for Sea-Doo 3D DI 951, 2006
• for Sea-Doo 3D DI 951, 2007

On-The-Job Use

• Routine driveshaft seal service
• Hull pass-through resealing during driveline repair
• Post-season maintenance on 951 DI watercraft
• Restoring watertight sealing after seal wear

Specs At A Glance

Good To Know

Q: Does this replace the original seal carrier on my 3D DI? A: It is a replacement seal carrier assembly that cross-references OEM 272000012400. Confirm your model and year match before ordering.

Q: Is this an original Sea-Doo part? A: This is an aftermarket replacement intended for Sea-Doo applications and is not an original brand item.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.