272000012400 Seal Carrier for Sea-Doo XP DI 951 2003-2004

Seal Carrier for Sea-Doo

The seal carrier is a driveline component that supports and seals the shaft where it exits the hull, and this unit cross-references OEM 272000012400.

Overview

This seal carrier is built to keep water out of the driveline while holding the shaft steady on 2003-2004 Sea-Doo XP DI 951 models. The seal carrier works alongside the carbon ring and bellows to maintain a stable running surface. It suits riders replacing a worn or leaking carrier in a personal watercraft driveline.

Built For Performance

• Direct-fit replacement for OEM cross-reference 272000012400
• Seals the shaft exit to help limit water intrusion
• Rigid body holds the shaft in alignment under load
• Mounting provisions match the factory attachment points
• Built to withstand continuous marine use

Fits These Machines

• for Sea-Doo XP DI 951 2003-2004

On-The-Job Use

• Routine driveline service on a Sea-Doo XP DI 951
• Repairs after a leaking or worn seal carrier is found
• Servicing the shaft seal area during hull maintenance

Specs At A Glance

Good To Know

Q: Does this seal carrier come with a seal installed? A: This listing is for the carrier as described by part number 272000012400, so check the listing contents for any included seal. Reuse or replace small seals depending on their condition.

Q: Why replace the seal carrier on a Sea-Doo XP DI 951? A: A worn carrier can let water past the shaft and allow the shaft to move, which wears surrounding parts. Replacing it restores a stable, sealed driveline surface.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.