272000024 Seal Carrier for Sea-Doo SPX 650 1994-1995 PWC Part

Seal Carrier for Sea-Doo

This seal carrier fits 1994-1995 Sea-Doo SPX 650 models and replaces OEM part number 272000024, holding the driveshaft seal securely in place to keep water out of the hull.

Overview

This seal carrier for Sea-Doo is a direct replacement component for the driveshaft sealing assembly on 1994-1995 SPX 650 watercraft. The seal carrier for Sea-Doo keeps the shaft seal aligned and protected so water stays out of the engine compartment. It is a practical replacement for riders maintaining an older SPX 650 or restoring a ski that has sat unused.

Built For Performance

• Replaces OEM part number 272000024
• Holds the driveshaft seal in correct alignment
• Designed for the 1994-1995 SPX 650 platform
• Helps prevent water intrusion at the shaft passage
• Simple bolt-on replacement for a worn or corroded carrier

Fits These Machines

• for Sea-Doo SPX 650 1994
• for Sea-Doo SPX 650 1995

On-The-Job Use

• Routine driveshaft seal service on older Sea-Doo models
• Restoring a ski that has taken on water at the shaft
• Seasonal maintenance before launching

Specs At A Glance

Good To Know

Q: Do I need to remove the driveshaft to install this carrier? A: In most cases the driveshaft must be pulled to reach the seal carrier, so plan for that step before starting. A: Refer to your service manual for the exact procedure on your model year.

Q: How do I know if my seal carrier needs replacing? A: Water in the hull near the shaft passage is the usual sign, along with a visibly cracked or corroded carrier. A: Inspect the seal and carrier together and replace both if either shows wear.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.