272000064 Support Ring for Sea-Doo GTI 720 1996-2005

Support Ring for Sea-Doo

The support ring, part number 272000064, is a driveline component that secures the bearing and shaft assembly on personal watercraft.

Overview

This support ring for Sea-Doo is a direct-fit driveline component that holds the driveshaft bearing and seals in place inside the hull tunnel. It keeps the shaft aligned and stable so the pump and engine stay properly coupled. This support ring for Sea-Doo is a smart replacement for a worn, corroded, or missing original piece during driveline service.

Built For Performance

• Reference part number 272000064 for straightforward cross-checking
• Rigid construction resists flex under driveshaft load
• Designed to seat the bearing and seal within the tunnel
• Helps maintain correct driveshaft alignment
• Corrosion-resistant material suited to marine environments

Fits These Machines

• for Sea-Doo GTI 720, 1996-2005

On-The-Job Use

• Driveline rebuilds and bearing replacement
• Routine hull and pump maintenance
• Restoring a PWC that has sat out of the water
• Seasonal pre-ride inspection and service

Specs At A Glance

Good To Know

Q: Does this part replace the original support ring? A: Yes, it is made to replace the factory support ring and is cross-referenced to part number 272000064. Always confirm your model and year before ordering.

Q: Can I install this myself? A: Many owners handle this during driveline service with basic tools, though bearing and shaft alignment should be checked carefully. A service manual for your model is a good reference.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.