272000065 Drive Shaft for Sea-Doo SPX 650 1994 17 Inch

17" Drive Shaft for Sea-Doo

This 17 inch drive shaft, OEM cross-reference 272000065, transfers engine power to the jet pump on the 1994 Sea-Doo SPX 650 watercraft.

Overview

This drive shaft is a direct replacement power transfer component for the Sea-Doo SPX 650, moving torque from the engine coupler to the jet pump assembly. Built to the 272000065 reference, it keeps the driveline of your 1994 SPX 650 turning true under load. It suits riders repairing a worn, bent, or broken shaft on a classic two-stroke machine.

Built For Performance

• 17 inch length matches the stock SPX 650 driveshaft
• OEM cross-reference 272000065 for straightforward parts matching
• Splined ends engage the coupler and pump shaft securely
• Constructed from corrosion-resistant steel for marine use
• Balanced to run true at high RPM
• Direct fit replacement, no modification required

Fits These Machines

• for Sea-Doo SPX 650, 1994

On-The-Job Use

• Restoring a 1994 SPX 650 after driveline failure
• Replacing a bent or corroded shaft during routine service
• Refreshing the jet pump drive on a vintage personal watercraft
• Keeping a classic Sea-Doo on the water for the season

Specs At A Glance

Good To Know

Q: Will this shaft fit my 1994 SPX 650 directly? A: It is built to the 272000065 reference and is intended as a direct replacement for the 1994 SPX 650 driveline. Confirm your model and serial number before ordering.

Q: Should I replace related driveline parts at the same time? A: When a shaft is worn, the coupler and pump bearings often show similar wear. Inspecting these while the shaft is out can save a second teardown.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.