272000183 Drive Shaft Bellow for Sea-Doo Challenger SE 2 x 260 1503 2012

Drive Shaft Bellow for Sea-Doo

This drive shaft bellow is a replacement driveline seal component that fits between the hull and the jet pump on select Sea-Doo watercraft, and it carries the OEM cross-reference 272000183.

Overview

This drive shaft bellow serves as the flexible sealing sleeve that surrounds the driveshaft where it passes through the hull on Sea-Doo personal watercraft and jet boats. The bellow keeps water out of the engine compartment while allowing the shaft to spin and articulate under load, protecting the driveline from corrosion and debris. It is intended for owners and mechanics servicing a Sea-Doo Challenger SE or comparable 1503-powered model that calls for the 272000183 bellow.

Built For Performance

• Flexible rubber construction absorbs vibration and shaft movement while maintaining a watertight seal
• Direct cross-reference to OEM part 272000183 for straightforward replacement
• Designed to resist the constant flexing and wet environment of a jet drive driveline
• Keeps water and debris out of the hull where the driveshaft exits the engine bay
• Replaces a cracked, hardened, or torn bellow that could allow water intrusion

Fits These Machines

• for Sea-Doo Challenger SE 260 (2012)
• for Sea-Doo Challenger SE 215 (2012)
• for Sea-Doo 1503-powered models using part 272000183

On-The-Job Use

• Routine driveline maintenance when the old bellow shows cracking or stiffening
• Hull and jet pump service where the driveshaft passes through the bulkhead
• Repairs after water intrusion is found around the driveshaft exit point
• Refurbishment of a jet boat or PWC being returned to the water

Specs At A Glance

Good To Know

Q: How do I know if my drive shaft bellow needs replacing? A: Common signs include cracks, stiffness, or a rubber sleeve that has collapsed or torn where it wraps the driveshaft. Replacing it before water intrusion reaches the engine bay helps prevent driveline corrosion.

Q: Does this bellow come with clamps or mounting hardware? A: The listing describes the bellow itself, so check your existing hardware and confirm the part number 272000183 matches your model before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.