272000183 Drive Shaft Bellow for Sea-Doo Challenger SE 430 1503 2008-2011

Drive Shaft Bellow for Sea-Doo Challenger SE 430 1503

The Drive Shaft Bellow for Sea-Doo Challenger SE 430 1503 is a replacement rubber boot that seals the drive shaft pass-through and keeps water out of the hull, referencing OEM part 272000183.

Overview

This Drive Shaft Bellow is a direct-fit sealing boot for the Sea-Doo Challenger SE 430 1503 jet boat drive line. The bellow for Sea-Doo Challenger models flexes with the shaft to keep cooling water and debris on the correct side of the hull while the craft is running. It is intended for owners replacing a cracked, torn, or hardened boot on 2008 through 2011 models.

Built For Performance

• Reinforced rubber construction resists cracking and drying out
• Corrugated profile flexes with the drive shaft through its full range
• Preformed shape seats onto the hull opening and shaft collar
• Watertight sealing surface helps keep the bilge area dry
• Replacement for OEM part number 272000183

Fits These Machines

• for Sea-Doo Challenger SE 430 1503, 2008-2011
• for Sea-Doo Challenger SE 430, model years 2008 through 2011

On-The-Job Use

• Replacing a split or hardened drive shaft boot during hull service
• Routine maintenance on the jet pump and drive line
• Season prep work on a stored Sea-Doo Challenger SE 430
• Refit after pulling the drive shaft for inspection

Specs At A Glance

Good To Know

Q: Is this an original Sea-Doo part? A: This is a replacement drive shaft bellow for Sea-Doo Challenger SE 430 1503 models, cross-referenced to OEM part 272000183 and not manufactured by Sea-Doo.

Q: Does a torn bellow need prompt replacement? A: Yes. A cracked or split drive shaft bellow lets water enter along the shaft, so it should be replaced before the next launch.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.