272000183 Drive Shaft Bellow for Sea-Doo Challenger SP 310 1503 2010-2011

Drive Shaft Bellow for Sea-Doo Challenger SP 310 1503

This drive shaft bellow for Sea-Doo Challenger SP 310 1503 models seals the hull opening around the driveshaft to keep water out of the engine compartment on 2010-2011 watercraft, and it cross-references OEM part number 272000183.

Overview

This drive shaft bellow for Sea-Doo is a rubber seal that fits around the driveshaft where it passes through the hull, blocking water from entering the engine bay while the craft is underway. The bellow for Sea-Doo Challenger SP 310 1503 is a direct replacement for the factory seal referenced as OEM 272000183. It suits riders maintaining or restoring a 2010-2011 Challenger SP 310 1503 who want the driveshaft seal renewed before it fails.

Built For Performance

• Rubber construction made to flex with driveshaft movement while holding a watertight seal
• Direct replacement for OEM part number 272000183
• Ribbed bellow design absorbs vibration and misalignment at the hull pass-through
• Fits the 1503 engine platform used in 2010-2011 Challenger SP 310 models
• Sold as a single bellow unit

Fits These Machines

• for Sea-Doo Challenger SP 310 1503, 2010-2011

On-The-Job Use

• Replacing a cracked or hardened driveshaft bellow during routine hull maintenance
• Servicing the driveshaft seal after pulling the jet pump or engine
• Restoring a 2010-2011 Challenger SP 310 1503 before returning it to the water
• Preventive replacement to guard against water intrusion into the engine compartment

Specs At A Glance

Good To Know

Q: Does this bellow replace the factory seal on my 2010-2011 Challenger SP 310 1503? A: Yes, it is made to replace the seal referenced as OEM 272000183 on those models. Confirm the part number on your existing bellow or in your service manual before ordering.

Q: How do I know when the driveshaft bellow needs replacing? A: Cracks, hardening, or deformation in the rubber, or water found around the driveshaft pass-through, point to a worn bellow. Inspect it any time the jet pump or engine is out.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.