272000183 Drive Shaft Bellow for Sea-Doo Challenger Wake S/C 215 2007

Drive Shaft Bellow for Sea-Doo

This drive shaft bellow is a rubber sealing boot that fits over the driveshaft to keep water out of the hull and driveline, and it is a direct replacement cross-referenced to OEM part 272000183.

Overview

This drive shaft bellow for Sea-Doo seals the through-hull driveshaft opening on Challenger jet boats while letting the shaft rotate freely. Rubber bellows harden and crack with age, so replacing the bellow protects both the driveline and the hull seal. It is aimed at owners and mechanics servicing Sea-Doo jet boats powered by the 1503 engine.

Built For Performance

• Flexible rubber construction rated for continuous rotation and vibration
• Cross-references OEM part 272000183 for simple replacement
• Corrugated profile flexes with the driveshaft seat without binding
• Seals the hull opening against water and spray
• Withstands fuel, oil, and marine chemicals
• Direct-fit part that installs without modification

Fits These Machines

• for Sea-Doo Challenger Wake S C 215 (2007)
• for Sea-Doo Challenger 1503 models

On-The-Job Use

• Driveline maintenance on Sea-Doo Challenger jet boats
• Replacing a cracked or hardened original bellow
• Driveshaft or impeller service that requires bellow removal
• Pre-season service before putting the boat back in the water

Specs At A Glance

Good To Know

Q: Why replace the drive shaft bellow? A: Heat, fuel, and time harden the rubber until it cracks, which lets water travel into the hull along the driveshaft. Replacing it during driveline service prevents that water damage.

Q: Does this replace my original bellow directly? A: Yes, it performs the same sealing job and cross-references OEM part 272000183. Confirm your model and serial number before ordering, as fitment can vary between production runs.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.