272000183 Drive Shaft Bellow for Sea-Doo GTI SE 155 1503 2008-2014

Drive Shaft Bellow for Sea-Doo

The Drive Shaft Bellow for Sea-Doo, OEM 272000183, seals the driveshaft tunnel on 1503-powered GTI SE 155 watercraft to keep water out of the hull and grease in place.

Overview

This Drive Shaft Bellow for Sea-Doo fits between the hull and driveshaft to protect the through-hull passage from water intrusion while retaining lubricant around the shaft. The bellow is a direct replacement for OEM 272000183 and suits 2008 to 2014 GTI SE 155 models running the 1503 engine. It is made for riders doing routine driveline maintenance or replacing a cracked, hardened, or leaking boot.

Built For Performance

• Direct replacement for OEM part number 272000183
• Flexible rubber construction absorbs shaft movement and vibration
• Seals the driveshaft tunnel against water intrusion
• Retains grease at the shaft pass-through for lasting lubrication
• Resists hardening and cracking from fuel, oil, and sun exposure
• Fits 1503 engine GTI SE 155 models from 2008 through 2014

Fits These Machines

• for Sea-Doo GTI SE 155 1503 (2008-2014)

On-The-Job Use

• Routine driveshaft and through-hull seal replacement
• Fixing water leaks into the hull at the shaft tunnel
• Driveline service after pulling the engine or jet pump
• Repairing a torn or hardened bellow found during inspection
• Pre-season maintenance on 1503-powered GTI SE 155 craft

Specs At A Glance

Good To Know

Q: Is this an original Sea-Doo part? A: This is an aftermarket replacement bellow that cross-references OEM 272000183, so it is not an original brand product.

Q: How do I know it fits my craft? A: It is listed for 2008 to 2014 GTI SE 155 models with the 1503 engine, but you should confirm the part number on your existing bellow or in your service manual before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.