272000183 Drive Shaft Bellow for Sea-Doo RXP NA 1503 2007

Drive Shaft Bellow for Sea-Doo

This drive shaft bellow for Sea-Doo seals the hull pass-through around the driveshaft on 1503-powered watercraft, keeping water out and lubrication in, and matches OEM cross-reference 272000183.

Overview

This drive shaft bellow for Sea-Doo is a rubber boot that mounts where the driveshaft exits the hull on 1503 models. It blocks water from entering the engine bay and holds grease at the shaft joint for smooth operation. It is intended for owners servicing a 2007 RXP NA or any machine showing a worn or leaking bellow.

Built For Performance

• Flexible rubber body tolerates driveshaft flex and vibration
• Forms a watertight seal at the hull opening
• Keeps grease contained at the shaft coupling
• Direct replacement for OEM part 272000183
• Built to withstand constant marine water exposure

Fits These Machines

• for Sea-Doo RXP NA 1503
• for Sea-Doo RXT 1503

On-The-Job Use

• Driveshaft seal replacement during routine service
• Fixing water intrusion at the hull pass-through
• Driveline maintenance alongside pump removal
• Off-season inspection before the next launch

Specs At A Glance

Good To Know

Q: What causes a bellow to fail? A: Age, heat, and constant flexing harden the rubber until it cracks or tears, which lets water into the hull. Q: Is this an original Sea-Doo part? A: This is an aftermarket replacement that cross-references OEM 272000183, so verify your model and serial number before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.