272000183 Drive Shaft Bellow for Sea-Doo RXT 1503 2005

Drive Shaft Bellow for Sea-Doo

This drive shaft bellow for Sea-Doo watercraft seals the driveline tunnel where the driveshaft passes through the hull, keeping water out and grease in, and carries the OEM cross-reference 272000183.

Overview

This drive shaft bellow for Sea-Doo is a rubber sealing boot that fits around the driveshaft where it exits the hull on 1503-powered models. The bellow keeps lake water from entering the engine compartment while holding lubricant at the shaft joint. It suits riders maintaining a 2005 RXT or anyone servicing a leaking or cracked driveshaft seal.

Built For Performance

• Flexible rubber construction absorbs driveshaft movement without cracking
• Seals the hull pass-through to block water intrusion
• Retains grease at the shaft coupling for steady lubrication
• Direct replacement for OEM part 272000183
• Resists water, fuel, and oil exposure typical of marine use

Fits These Machines

• for Sea-Doo RXT 1503
• for Sea-Doo RXP NA 1503

On-The-Job Use

• Routine driveshaft and hull seal service
• Replacing a torn or hardened bellow after haul-out
• Driveline refresh during pump or impeller work
• Pre-season inspection of the shaft tunnel

Specs At A Glance

Good To Know

Q: How do I know if my bellow needs replacing? A: Look for cracks, stiffness, or grease weeping around the driveshaft tunnel, and replace it before water reaches the coupling. Q: Does this fit both the RXT and RXP? A: It is listed for 1503-powered RXT and RXP NA models, but confirm your year and serial number before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.