272000183 Drive Shaft Bellow for Sea-Doo Speedster 2 x 255 1503 2012

Drive Shaft Bellow for Sea-Doo Speedster 2 x 255 1503

The drive shaft bellow for Sea-Doo Speedster 2 x 255 1503 seals the driveshaft pass-through at the hull, keeping water out of the engine compartment while the shaft spins. It cross-references OEM part number 272000183.

Overview

This drive shaft bellow is a replacement seal built for the dual 1503 engine setup on the 2012 Sea-Doo Speedster 2 x 255. It keeps water and debris away from the driveshaft joint, helping protect bearings and internal components. It is a practical choice for owners servicing both drive lines on their sport boat.

Built For Performance

• Rubber construction resists cracking from constant flex and moisture
• Direct-fit replacement for OEM part number 272000183
• Seals the driveshaft joint against water intrusion
• Handles repeated flex without tearing under normal jet drive use
• Flexible material eases installation over the shaft

Fits These Machines

• for Sea-Doo Speedster 2 x 255 1503 2012

On-The-Job Use

• Replacing worn or cracked bellows during jet pump service
• Routine maintenance on 1503-powered Sea-Doo sport boats
• Restoring the watertight seal between hull and driveshaft
• Seasonal inspections before launching

Specs At A Glance

Good To Know

Q: How do I know the bellow needs replacing? A: Cracks, stiffness, or water pooling around the driveshaft in the engine bay usually signal a worn bellow that should be replaced.

Q: Does this fit my exact model year? A: Confirm your hull and serial number against OEM part number 272000183 before ordering, since fitment can vary by production run.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.