272000770 Carbon Ring for Sea-Doo 3D DI 951 2006-2007

Carbon Ring for Sea-Doo

The carbon ring is a sealing component used in the driveline of personal watercraft, and this replacement cross-references OEM part number 272000770 for a proper fit.

Overview

This carbon ring serves as a sealing element in the jet pump driveline of Sea-Doo personal watercraft. The carbon ring helps maintain a proper seal between the driveshaft and the hull pass-through, reducing water intrusion into the engine compartment. It is intended for riders and mechanics servicing 2006-2007 Sea-Doo 3D DI 951 models.

Built For Performance

• Carbon construction for durable sealing performance
• Direct cross-reference to OEM part number 272000770
• Designed to seal the driveshaft pass-through area
• Helps limit water entry into the engine compartment
• Suited for routine driveline maintenance and replacement

Fits These Machines

• for Sea-Doo 3D DI 951, 2006-2007

On-The-Job Use

• Driveline sealing during jet pump service
• Routine replacement of worn carbon rings
• Engine compartment water intrusion prevention
• Personal watercraft maintenance and repair

Specs At A Glance

Good To Know

Q: Does this carbon ring fit other Sea-Doo models? A: This ring is referenced for the 2006-2007 Sea-Doo 3D DI 951. Verify your model and part number before ordering.

Q: How often should a carbon ring be replaced? A: Replacement intervals depend on use and wear, and a worn or damaged ring should be replaced to maintain a proper seal during driveline service.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.