272000770 Carbon Ring for Sea-Doo Challenger 800 1996-1997

Carbon Ring for Sea-Doo

This carbon ring, part number 272000770, is a replacement driveshaft seal component that helps prevent water intrusion on Sea-Doo Challenger 800 models from 1996 to 1997.

Overview

This carbon ring for Sea-Doo functions as a sealing element within the driveshaft assembly of the Challenger 800 watercraft. The carbon ring for Sea-Doo presses against the floating ring to create a wear surface that limits water entering the hull at the driveshaft pass-through. It suits riders and mechanics handling routine driveline service on 1996 to 1997 Challenger 800 models.

Built For Performance

• Carbon construction for a smooth, low-friction wear surface
• Designed as a direct replacement for part number 272000770
• Helps seal the driveshaft pass-through against water intrusion
• Fits the carbon seal assembly on the Challenger 800 platform
• Compact ring shape simplifies installation during seal service

Fits These Machines

• for Sea-Doo Challenger 800, 1996-1997
• for Sea-Doo Challenger 1800 800, 1997-1999

On-The-Job Use

• Routine driveshaft seal replacement during seasonal maintenance
• Repairing water intrusion found at the hull pass-through
• Servicing the carbon seal assembly after removing the driveshaft
• Shop or DIY jet pump and driveline upkeep on Challenger models

Specs At A Glance

Good To Know

Q: Is this carbon ring a genuine Sea-Doo part? A: This is a replacement carbon ring made for Sea-Doo applications and is not an original manufacturer part. It is referenced by part number 272000770 for identification.

Q: Should the sealing surfaces be inspected when replacing the carbon ring? A: Yes, the mating ring and boot should be checked for wear or damage whenever the carbon ring is replaced. Replacing worn sealing surfaces together helps prevent repeat water intrusion.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.