272000770 Carbon Ring for Sea-Doo GTX LTD 951 1998-1999

Carbon Ring for Sea-Doo

The carbon ring for Sea-Doo personal watercraft seals the driveshaft at the through-hull point, preventing water intrusion on GTX LTD 951 models built in 1998 and 1999.

Overview

This carbon ring for Sea-Doo is a replacement sealing component for the driveshaft through-hull assembly on GTX LTD 951 watercraft. The carbon ring for Sea-Doo pairs with the bellows and carrier to hold a watertight seal while the shaft rotates. It is intended for owners servicing a 1998 or 1999 GTX LTD 951.

Built For Performance

• Carbon face provides a low-friction running surface against the shaft
• Manufactured to OEM dimensions for straightforward installation
• Resists continuous water exposure and rotational wear
• Matches the 272000770 reference number for quick confirmation
• Sized for the GTX LTD 951 through-hull assembly

Fits These Machines

• for Sea-Doo GTX LTD 951, 1998
• for Sea-Doo GTX LTD 951, 1999

On-The-Job Use

• Replacing a scored or worn ring during driveshaft service
• Routine hull and driveline maintenance
• Restoring a watertight seal on a high-hour GTX LTD 951
• Shop and DIY rebuilds of the through-hull assembly

Specs At A Glance

Good To Know

Q: How do I know when the carbon ring needs replacing? A: Check it whenever the driveshaft or bellows is serviced and replace it if the sealing face shows scoring, cracks, or uneven wear.

Q: Is the bellows included with this ring? A: No, this listing is for the carbon ring only, so inspect and replace the bellows and carrier separately as needed.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.