272000770 Carbon Ring for Sea-Doo HX 720 1995-1997 PWC

Carbon Ring for Sea-Doo

This carbon ring is a driveshaft seal component that fits 1995 to 1997 Sea-Doo HX 720 models, and it works with OEM cross-reference 272000770 to keep the driveline sealed.

Overview

The carbon ring for Sea-Doo HX 720 seats against the stainless ring at the driveshaft and seals the through-hull passage. This carbon ring stops water from working past the driveline into the engine bay on 1995 to 1997 HX 720 craft. It suits riders replacing a worn sealing face during pump or impeller service.

Built For Performance

• Replaces worn carbon sealing rings on the driveshaft
• Machined carbon face designed to seat against the mating stainless ring
• Supports the through-hull seal so the bilge stays dry
• Direct fitment for 1995 to 1997 Sea-Doo HX 720 models
• Cross-references 272000770 for easy lookup

Fits These Machines

• for Sea-Doo HX 720, 1995
• for Sea-Doo HX 720, 1996
• for Sea-Doo HX 720, 1997

On-The-Job Use

• Driveline seal replacement during winterization
• Routine hull maintenance on the HX 720
• Resealing the driveshaft after impeller or pump service
• Refreshing the sealing surface during engine rebuilds

Specs At A Glance

Good To Know

Q: Does this carbon ring come with the mating stainless ring? A: This listing covers the carbon ring only, so inspect the stainless ring surface before install. Q: Can I reuse the old boot and clamp? A: The boot and clamp can be reused if they are pliable and undamaged, but replacing them together is common practice.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.