272000770 Carbon Ring for Sea-Doo RX DI 951 2000-2003

Carbon Ring for Sea-Doo

This carbon ring, part number 272000770, is a driveshaft sealing component that controls water flow and protects the driveline on Sea-Doo RX DI 951 watercraft.

Overview

This carbon ring is a replacement sealing component for the driveshaft assembly on the Sea-Doo RX DI 951. It manages the seal interface where the driveshaft passes through the hull, helping reduce water intrusion and keeping the driveline running properly. As a direct-fit replacement for part number 272000770, this carbon ring serves riders maintaining 2000 to 2003 Sea-Doo RX DI 951 models.

Built For Performance

• Direct cross-reference to part number 272000770
• Carbon sealing face engineered for the driveshaft interface
• Helps control water entry at the through-hull seal point
• Suits routine driveline service and rebuild intervals
• Lightweight component that installs without special tooling

Fits These Machines

• for Sea-Doo RX DI 951 (2000-2003)

On-The-Job Use

• Driveline maintenance and carbon seal replacement
• Off-season teardown and inspection
• Reviving a watercraft with a worn or leaking seal
• Preventive service on the driveshaft assembly

Specs At A Glance

Good To Know

Q: What does a carbon ring do on a Sea-Doo? A: It provides the sealing surface where the driveshaft exits the hull, working with the bellows and support ring to limit water entry. A worn ring can allow seepage, which is why it is often replaced during driveline service.

Q: How do I verify this ring fits my watercraft? A: Match part number 272000770 against your model and serial number before ordering. Fitment can differ across production years, so checking the part number against your diagram is recommended.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.