272000770 Carbon Ring for Sea-Doo Sportster LE DI 951 2004-2006

Carbon Ring for Sea-Doo Sportster LE DI 951

This carbon ring seals the driveshaft to the hull on 2004 to 2006 Sea-Doo Sportster LE DI 951 models and cross-references OEM 272000770.

Overview

The carbon ring for Sea-Doo Sportster LE DI 951 is the sealing component that runs against the floating ring at the driveshaft tunnel to keep water out of the engine bay. This carbon ring for Sea-Doo watercraft uses a spring-loaded face seal design to maintain contact as the shaft spins. It suits riders and mechanics replacing a worn or leaking seal on a 951-powered Sportster LE DI.

Built For Performance

• Carbon graphite sealing face for low friction against the stainless floating ring
• Rubber bellows keeps constant pressure on the seal face through the driveshaft tunnel
• Spring loaded design holds contact under vibration and shaft runout
• Direct replacement footprint matching OEM 272000770
• Resistant to fresh and salt water splash in the engine compartment

Fits These Machines

• for Sea-Doo Sportster LE DI 951, 2004 to 2006

On-The-Job Use

• Routine driveshaft seal replacement during pump or engine service
• Fixing water intrusion into the engine bay on 951-powered Sportster models
• Rebuilds after a worn carbon face starts leaking under load

Specs At A Glance

Good To Know

Q: Does this ring come with the floating ring and boot? A: This listing covers the carbon ring only; check whether the mating floating ring and bellows need replacing at the same time. Q: Can this be installed without removing the engine? A: On most Sportster LE DI models the driveshaft seal can be serviced from the pump side, though access varies by hull layout.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.