2736CS Ring Set 69.50mm for Wiseco Piston Rings

Ring Set for Wiseco 69.50mm

This 69.50mm ring set is a piston ring replacement designed for Wiseco applications, built to seal combustion pressure and control oil on the cylinder wall.

Overview

The Wiseco 69.50mm ring set supplies the rings needed to complete a piston assembly for Wiseco 2736CS applications. This ring set is made for riders and engine builders refreshing top ends where bore size matches 69.50mm. Each ring set is sized to the stated 69.50mm bore so the piston seals correctly inside the cylinder.

Built For Performance

• 69.50mm bore sizing matched to the listed Wiseco piston
• Ring set configuration for a single piston assembly
• Designed to seal combustion pressure between piston and cylinder wall
• Helps control oil consumption during engine operation
• Direct replacement for the ring set referenced by the 2736CS number

Specs At A Glance

Good To Know

Q: Is this a complete ring set for one piston? A: This is a ring set sized at 69.50mm intended to supply the rings for a piston assembly of that bore. Confirm the ring count matches your piston before ordering.

Q: Can I install this without checking end gap? A: Ring end gap should always be measured and set to the engine manufacturer specification before assembly. Installing rings without checking gap risks poor sealing or damage.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.