277000775 Cable End for Sea-Doo GTR 230 1630 2020-2026

Cable End for Sea-Doo

This cable end is a replacement control cable terminal for Sea-Doo personal watercraft, designed to connect and secure the cable to its attachment point so throttle, steering, or reverse actuation stays tight and predictable.

Overview

This cable end fits Sea-Doo watercraft and serves as the terminal fitting that anchors a control cable at the lever or nozzle end. A worn or corroded cable end can cause sloppy engagement, so replacing it restores crisp response from the handlebars to the system it controls. It is a practical service part for riders and shops maintaining a Sea-Doo PWC.

Built For Performance

• Direct replacement for the factory cable terminal
• Stamped metal construction resists bending under cable load
• Fits cable ends used across multiple model years
• Simple bolt-on or pin-on installation with basic hand tools
• Restores positive cable engagement at the attachment point
• Lightweight design adds no measurable load to the cable

Fits These Machines

• for Sea-Doo GTR 230 1630 (2020-2026)

On-The-Job Use

• Routine steering and control cable service
• Replacing a corroded or stretched terminal at the nozzle end
• Seasonal maintenance before riding season
• Shop repairs on Sea-Doo personal watercraft

Specs At A Glance

Good To Know

Q: Do I need to replace the whole cable when the end wears out? A: In many cases the cable itself is still serviceable and only the terminal needs replacement. Inspect the cable sheath and core for fraying before you commit to a full cable swap.

Q: Is this part difficult to install? A: Cable end replacement is a straightforward task that typically requires basic hand tools and a few minutes of adjustment. Check cable free play after installation to confirm proper operation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.